$14000.00 - $15000.00/Sets | 1 Sets (Minimum Order Quantity)
The device is suitable for power conversion, distribution and control of power distribution, power distribution and motor control center, capacitance compensation and other low-voltage power distribution system, such as power plant, substation, petrochemical industry, factories and mines, high-rise buildings.
In the large stand-alone power plant, large-scale petrochemical industry and other low-voltage power control center and the motor control center and other power use occasions, to meet the special needs of the computer interface.
The device is based on the power of the competent superiors, the majority of power users and design departments to meet the continuous development of the electricity market capacity, computer interface, power centralized control, easy installation and maintenance, shorten the time to deal with accidents and other needs, Economic, reasonable and reliable design of the new low-voltage withdrawable switchgear. Products with breaking, high capacity, good thermal stability, electrical solutions flexible, convenient combination, the series of practical, new structure, high degree of protection. Can be used as a low-voltage withdrawable switchgear replacement products.
Device in line with IEC60439-1, GB / T9661 "low-voltage withdrawable switchgear" and other standards.
Use environmental conditions
1. The ambient air temperature is not higher than +40 ° C and not less than 5 ° C. The average temperature in 24 hours should not exceed + 35 ° C. When it is over, it is necessary to run according to the actual situation.
2. Indoor use, the use of the altitude of not more than 2000m.
3. The relative humidity of the ambient air does not exceed 50％ at a maximum temperature of + 40 ° C and 90％ at a lower temperature, such as a maximum relative temperature, such as + 20 ° C, taking into account the temperature Changes may occasionally produce the effects of condensation.
4. The installation of the installation and the vertical surface of the tilt of not more than 5％, and the entire cabinet column is relatively flat (in line with GB / T232 standard).
5. The device shall be installed in places where there is no severe vibration and shock and is insufficient to cause electrical components to be protected from corrosion.
Rated insulation voltage(V)
Rated current of horizontal bus
Rated peak tolerance current
Rated current of vertical bus
Rated short-time tolerable current(1s)
互感器, 真空断路器, 熔断器, 隔离开关, 高低压成套设备